As to the painter, we do not tow the dink so a sturdier painter that floats (so as to not get into the boats propeller when we are in reverse) is not needed; we can simply use the one that came with the dink.
The need for a new snubber line arose because the old one was getting shorter and thinner. After being anchored for a long time during strong winds, it takes either patience with the marlinspike or just cutting off the last nine inches to undo the snubber where it is clove hitched to the anchor chain. This has happened several times and the line was getting progressively shorter. Also it was getting thinner, because of severe chafing. So time for a new one. You want this line to stretch so most of the lines we have aboard are not good for this purpose because they were made for other purposes, where you want the lines to NOT stretch. So Im looking at Westmarines selection of lines and -- wait a minute! I have an old soft stretchy nylon anchor rode. If I cut off a 25 foot length, this will work quite well with lots of line left for cutting off nine inches at a time over the next several years. But, I spent $100 on a good hardened stainless lock to prevent theft of the outboard from the dink.
Back at the dock, I installed the lock and hacked off another half foot of the tiller extender because it extended too far. The marinas bike took me the five minute ride to the local, less upscale Publix for two items Lene wanted.
Heading out back to ILENE, a terrible thing happened. In driving the dink at the dock, I bounced it off another dink into one of the concrete pilings, from which clam shells extended out like razors. WHOOSH! was the sound of the air escaping from a 1.5 inch gash, below the waterline in the port aft tube. Our almost brand new dink, wounded already! Are we destined to be cursed with dinghy problems? The dink can stay afloat with only one of its three tubes inflated, so is in no danger of sinking, but this was a most revolting development.
I hauled the dink up onto the Martinas dinghy dock and water that had entered the tube, which was quite flabby, poured out. The marina gave me a ride back to ILENE for the repair kit, sandpaper, and a pair of scissors to shape the patch into a diamond shape with rounded corners. You have to sandpaper both surfaces and mix a two part glue and apply it to the dink and the patch. I needed help in the form of tools from the marina office to open the two glue bottles. You have to use a metal or glass container to mix the two parts of the glue, hopefully in the correct nine to one proportions. the bottom of a beer can from a trash bin was the metal surface and its tab was the stirrer. I let the glue get tacky but not as long as the instructions called for, and slapped it into place as the first few drops of torrential rain hit. I let it cure for over two hours while reading in the Marinas clubhouse -- free popcorn! Then I drove the dink back to the boat, without inflating the tube in question to full pressure. The instructions say to not pressure test the patch for 24 hours. Well the patch did not fall off, but it has a fast "slow leak" requiring it to be pumped up each 24 hours. So we will try to have the job done by a professional in St. Augustine in a few days. My not so handy work:
The passage to Fort Pierce was not long. But with temperatures in the low 50s, a hard, cold 30 knots of apparent wind 20 degrees off the port bow made for quite a wind chill factor. (Yes, I know, I shouldnt be complaining to northern friends who have suffered a cruel winter.) But it makes us fear that we may have started north too soon. Anyway, hats, gloves and scarves were in order. Just a slog under grey skies. Not a peak sailing experience, in fact solely a motoring experience.
The Fort Pierce Municipal Marina has been redone since our charts were printed, after a hurricane took out much of the old marina. They spent a lot of money to build a series of barrier islands to prevent such damage. The new slips are almost ready for occupancy and we went to the remaining portion of the old, via a well marked but tricky new channel that is not on the charts yet. The tricky part is the current, which runs wicked strong N-S across the E-W channel. We had to go west but headed NW to "crab" through it diagonally. They put us starboard side to, on the outside "T" dock, opposite the fuel dock, so when we leave we make a "U" turn to port and our lines are set up for fueling.
The Marina is different from others in our experience in that a number of live-aboarders have cats rather than dogs. Playmates for our dynamic duo, but they grew up playing with each other, our pair get low grades in "playing well with others."
We arrived too late for the "biggest farmers market in Florida" but wandered through a large music festival on our way to the marina office: rock, blues, country, etc. Crowds were still arriving; we were serenaded that night. Normally, readers know, we explore a town and learn of its history, etc. But here we just hung out with friends. Janet and Mike, with whom we had dined on Greek food in Boca, invited us to their home for happy hour and took us to Publix on our way home the first evening there and to their home where Kathryn and Craig had come up from Boca to visit, the next. After this second happy hour we went out to the Second Street Cafe for dinner.
We hope to meet up with Janet and Mike in Oxford Maryland on our way home. Its amazing. We last saw them in Maryland in 2012 and Kathryn and Craig at her brothers wedding maybe six years ago. But put sailors together and the old bonds are re-cemented instantly-- a lot stronger than the two part glue fixing our Hypalon patch to the dink. Mike and Janet just moved into their new, large modern apartment facing east over the water on the fourth floor.
 |
| Rear view from entrance |
 |
| Front view, with Atlantic past the barrier island. |
 |
| View to the left, with free anchoring where we will stay next time. |
0 komentar:
Posting Komentar